Curved Metal Roofing

Metal Roofing by Imetco

Curved Metal Roofing Options with the 300 Series

The dynamic nature of a metal roofing is embraced and facilitated by the Series 300 system. The unique one-piece concealed clip, made of heavy 16-gauge galvanized or stainless steel, is designed to provide maximum structural integrity while allowing unlimited thermal movement. The clip also elevates the panel 3/8-inch off the substrate to allow for air movement. Where once a metal roof was thought of as only being a static flat structure the unique design of the 300 Series by Imetco allows for convex – concave and even “ s “ curves.

The one-piece clip, isolated seam sealant, custom trim, flashing, and system details all work together to accommodate the natural expansion and contraction of metal that occurs when it is exposed to varying temperatures. Each Series 300 roof is engineered for unlimited thermal movement to maintain the roof’s structural integrity and provide a lifetime of watertight protection.

Performance-Inspired • Precision-Engineered Metal Roofing

  • Long-term weather-tight performance
  • Custom trim and flashing details available
  • One-piece clip allows unlimited thermal movement
  • Rigorously tested for leaks and hurricane-force winds
  • Ideal for structural and/or architectural applications
    • Can be installed over open purlins or solid decks
    • Suitable for slopes as moderate as ¼:12 or on steeper slopes
    • Available vertically as a wall panel
  • 2-3/8″ symmetrical seam with a separate, easy-to-install seam cap
  • Factory-applied hot-melt sealant that remains isolated from the clip
  • 3/8″ clearance between panel and substrate promotes ventilation
  • 12-inch, 16-inch, and 18-inch panel widths
  • Wide variety of materials and colors

Specialty Manufacturing Metal Roofing Options

  • Curving (convex, concave and “S” curves)
  • Tapering (to more than 80-feet in length)
  • Long panel factory manufacturing (up to 85 feet)
  • On-site fabrication of factory-quality straight or curved panels is available

Curved Metal Roofing metal roofing Metal Roofing by Imetco 2012 03 27 180 DorianPhotoInc

  • Sleek, balanced, proportional look that complements any design
  • No interlocking male/female seams to worry about gives installers better control over when and where panels are installed
    • Install panels in either direction, or both directions, at any time
    • Start from any point on the roof
    • Run simultaneous crews to cut completion time in half
    • Work around roof protrusions and other obstacles
  • Mechanical seamer quickly and permanently seals the seam caps at a rate of 60 feet per minute, and runs in both directions
  • Reduces waste since each piece of a cut panel can be used for the opposite sides of a detail condition
  • If a panel needs to be removed or replaced, ONLY that panel needs to be removed or replaced – not every other panel between it and the roof’s edge

For more information about curved metal roofing systems contact Alpine Roofing Construction. or go to the company site